Large Lidded Box (inspired by Pootles)
12”x12” card stock score at 4” on all sides
6”x6” DSP score at 7/8” on all sides
Basic White 5 ½”x 8 ½” (for decorations)
- Score at 4” on all sides
- Burnish 12”x12” on all score lines
- Cut up to 4” & wedge
- Then Trim about 1 ½” off end of the tab
- Flip cardstock over & use Seal+ or Tear Tape to be able to adhere the tabs
- Then flip back over and adhere the tabs
- Do the same to the Lid with the DSP – it should fit snuggly on top of the box
Treat Bag (you get 2 out of this)
12”x12” Designer Series paper score at 1”, 4 ¾”, 7”, 10 ¾”
Rotate 90-degrees and score at 4”, 5 ¾”, 9 ¾”, 11 ½”
Basic White scraps for tag & dots & inside bag
two pieces of Ribbon about 8” long
- with the ½” at the top cut at 6” (you now have two bags)
- cut the rectangle ends off either end of the ½” and wedge the ends
- on the 1 ¼” side, cut & wedge all score lines
- Flip over DSP & fold the 1” side down (this is your band)
- Now fold and burnish all score lines
- Using Tear Tape or Seal+ on one of the long bottom tabs. Fold in the two smaller tabs, fold in one long tab, and adhere with adhesive. Use bone folder to firm up adhesive
- Cut a piece of BW 4”x1 ¾” for inside the bag
- Using a hole approximately 1 ½” from either side on both long sides of bag
- punch 4 circles with ¾” circle & use Take your pick tool to punch a hole in center
- tie knot in one end of ribbon and thread through ¾” circle and from inside bag and through other hole. Add ¾” circle to other end and tie a knot. Repeat on other side.
Keep on Crafting!
Francine Wilson
Independent Stampin’ Up! Demonstrator
